2005 Ford Focus Keyless Entry Remote Fob Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

2005 Ford Focus

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 2005 Ford Focus


FORD FOCUS KEY FOB REMOTES STEP-BY-STEP HOW TO PROGRAMMING INSTRUCTIONS

Minutes 5 minutes

  1. Prepare Vehicle

    CLOSE and UNLOCK all doors using the power door locks.

    BUCKLE seat belts.

  2. Enter Programming Mode

    INSERT key into Ignition and TURN from OFF to RUN 4 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm Programming Mode.

  3. Program Remote(s)

    Within 20 seconds press any button on first keyless remote fob. Door locks will cycle Lock/Unlock to confirm programming.

  4. Program Additional Remote(s)

    REPEAT the previous step IMMEDIATELY for any other remotes to be programmed to your vehicle.

  5. Exit Programming Mode

    Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.

  6. Test Remote(s)

    TEST all remotes. Programming is now complete.

  7. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Supply:

  • Key Fob Remote(s) that you want to program to your vehicle.

Tools:

  • None

Important:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes. You must program all existing and new remotes that you wish to use on the vehicle at this time.
  • You may clear your keyless entry system memory by entering programming mode as shown in the steps above.

Note: If your vehicle cannot enter programming mode, then you cannot program any remote.  This indicates either no keyless entry installed on the vehicle or a defective keyless entry receiver module.


If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

2005 Ford Focus

OEM Electronic
NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

4 thoughts on “2005 Ford Focus Keyless Entry Remote Fob Programming Instructions

  1. Nicklas Chaput says:

    Hello. Your instructions are helpful, however I do not have a first keyless remote for programming, will that be an issue?

  2. Dianne Guinn says:

    Hi there. 2005 focus zx4 st here. My steering column was handled by gorillas. The immobilizer module (with straitec key taped inside it) hangs freely from four wires) And then using a flat file we can turn. Ignition to any position. Even start n drive it. Like a hot puma running down the road. For last 18 months.
    6 wks ago, 1 wire comes lose from module, antitheft kicks in, hasn’t started since.
    Will I be able to program a fob with the neck hanging out like that?

Leave a Reply

Your email address will not be published. Required fields are marked *