2005 Kia Sorento Keyless Entry Remote Fob Programming Instructions

Easy to Follow Step-by-step Key fob remote Programming Instructions

2005 Kia Sorento

We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.

Many people don’t know that they can purchase their own replacement vehicle entry remote, save up to 70% off of marked up Dealership prices, and program the replacement remote to their vehicle themselves. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Free Key Fob Remote Programming Instructions for a 2005 Kia Sorento


Time needed: 5 minutes.


KEY FOB REMOTE
Step-By-Step How To Programming Instructions

  1. Enter Programming Mode – Step 1

    OPEN the hood of your vehicle.

  2. Enter Programming Mode – Step 2

    LOCATE the DIAGNOSTICS port (labeled) that is situated behind the vehicle battery on the Driver’s side of the vehicle.

  3. Enter Programming Mode – Step 3

    OPEN the plastic cover of the DIAGNOSTICS port by pulling up on the edge closes to the FRONT of the vehicle.

  4. Enter Programming Mode – Step 4

    PLACE one end of the jumper wire in Connector 6 of the port.

  5. Enter Programming Mode – Step 5

    CONNECT the other end of the jumper wire to the POSITIVE terminal on your vehicle battery. Push it into place so that it stays there on its own. You have now successfully entered Programming Mode.

  6. Program Remote – Step 1

    SIT in the Driver’s seat with the remote fobs you are programming.

  7. Program Remote – Step 2

    INSERT key into the Ignition and TURN to the ON position (just shy of cranking engine).

  8. Program Remote – Step 3

    IF you have ONE key fob to program:

    HOLD the LOCK button on the fob for 3 seconds.
    The Dashboard panel lights will go off signaling successful programming of the remote.

    IF you have TWO key fobs to program:

    HOLD the LOCK button on the first fob for 1 second.
    HOLD the LOCK button on the second fob for 1 second.
    The Dashboard panel lights will go off signaling successful programming of the remote.

  9. Exit Programming Mode

    REMOVE key from Ignition to EXIT Programming Mode.

  10. Test Remotes

    TEST all remotes. Programming is now complete.

  11. Share

    If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Programming Notes:

  • Verify the following prior to following these instructions:
    • Your vehicle is equipped with keyless entry, and
    • You have a key fob remote that is compatible with your vehicle.
  • Obtain ALL remote transmitters for this vehicle.
  • You may program up to 2 remotes to your vehicle.
  • Important: In order to jump the vehicle into Programming Mode, you will need 1.5 foot or more of electrical wire, with ends stripped, approximately 22 gauge (jumper wire).

If you have any difficulties with programming your vehicles, contact us at [email protected].

Key fob remotes

2005 Kia Sorento

OEM Electronic
NorthCoast Keyless Free Programming Instructions Disclaimer:
  • We worked hard to provide these instructions to our customers. We checked multiple sources to ensure that this information is complete and accurate. However, please understand that we cannot be held liable for any loss due to incorrect use of the programming instructions from www.northcoastkeyless.com.
  • If you cannot program your remote with the instructions that we provide or encounter any discrepancies, please contact us at [email protected] and we’ll make sure that you’re taken care of.

Leave a Reply

Your email address will not be published. Required fields are marked *